MDH
mh teclamppos
Magnus_VLF
This NVS parameter holds the drum position required to actuate the TEC when the backbone is
in its center position. This is in degrees to 3 decimal places.
This is the drum position where the TEC is at the position such that a 0 mm length mainscan
is to be clamped to the drum. Normally by moving to this position will result in the TEC
being adjacent to the LEC.
Any changes in the parameter will affect the length of plate being clamped by the TEC.
This parameter normally is set buy using the monitor command "engine calibrate postions".
To use this command, the drum must first be initialized using the command "drum init", then
the drum should then be idled using "drum idle". The roller should be sent down "roller down"
then the drum should be moved by hand so that the LEC is placed flush to the backside
of the roller (the LEC is on the same side as the back panel). The command
"engine calibrate positions" should then be entered at the monitor prompt.
Currently this position is set by adding adding a set value (hardcoded in the firmware)
to the drum position found when the LEC is positioned flush to the back side of the roller.
By changing this value, or recalibrating this value, the command "load calibrate" should
also be run in order to compensate for other parameters that this might affect.
** Caution ** By changing this value directly, you may be causing unforseen problems in other areas
This parameter is available.
Please issue the appropriate monitor command to determine this parameter's default value.
Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.
4 Jan 2001
Automated conversion to new FW1 parameter template.
Normal
..\..\ShowAllErrors.htmFirmware 1 Error Index
..\..\ShowAllCommands.htmFirmware 1 Command Index
..\..\ShowAllParameters.htmFirmware 1 Parameter Index